HP ProCurve 7102dl Reference Manual page 439

SROS Command Line Interface Reference Guide
ip radius source-interface <interface>
Use the ip radius source-interface command to specify the NAS (network-attached storage) IP address
attribute passed with the RADIUS authentication request packet.
Syntax Description
<interface>
Default Values
By default, no source interface is defined.
Functional Notes
If this value is not defined, the address of the source network interface is used.
Usage Examples
The following example configures the Ethernet 0/1 port to be the source interface:
ProCurve(config)#ip radius source-interface ethernet 0/1
The following example configures the BVI 1 interface to be the source interface:
ProCurve(config)#ip radius source-interface bvi 1
5991-2114
Specifies the source interface (in the format type slot/port). Type ip radius
source-interface ? for a complete list of interfaces.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
437