Dsx-1 Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
DSX-1 I
NTERFACE
To activate the DSX-1 Interface Configuration mode, enter the interface t1 command (and specify the
DSX-1 port) at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface t1 1/2
ProCurve(config-t1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
coding [ami | b8zs]
framing [d4 | esf] on page 593
line-length <value>
loopback network [line | payload]
loopback remote line inband
remote-loopback on page 597
signaling-mode [message-oriented | none | robbed-bit]
snmp trap link-status
test-pattern [ones | zeros]
5991-2114
C
ONFIGURATION
on page 1434
on page 592
on page 594
on page 595
on page 596
on page 599
on page 600
© Copyright 2007 Hewlett-Packard Development Company, L.P.

DSX-1 Interface Configuration Command Set

C S
OMMAND ET
on page 598
on page 1431
591