Hdlc Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
HDLC C
OMMAND
To activate the HDLC mode, enter the interface hdlc command at the Global Configuration mode prompt.
For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface hdlc 1
ProCurve(config-hdlc 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
alias link<"text">
backup commands
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dynamic-dns on page 994
fair-queue <threshold>
hold-queue <queue size> out
ip commands begin on page 998
keepalive <seconds>
lldp receive on page 1024
lldp send [management-address l port-description l system-capabilities l system-description l
system-name] on page 1025
lldp send-and-receive
5991-2114
S
ET
on page 1434
on page 971
on page 972
begin on page 973
on page 990
on page 991
on page 992
on page 996
on page 997
on page 1023
on page 1026
© Copyright 2007 Hewlett-Packard Development Company, L.P.

HDLC Command Set

on page 1431
969