HP ProCurve 7102dl Reference Manual page 732

SROS Command Line Interface Reference Guide
backup number <digits> [analog | digital-56k | digital 64k]
<isdn min chan> <isdn max chan> ppp <interface>
Use the backup number command to configure the phone number and the call type the router will dial
upon network failure. Multiple entries can be made for an interface to allow alternate sites to be dialed. For
more detailed information on backup functionality, refer to the Functional Notes section of the command
backup call-mode <role> on page 723.
Syntax Description
<digits>
analog
digital-56k
digital-64k
<isdn min chan>
<isdn max chan>
ppp <interface>
Default Values
By default, there are no configured backup numbers.
Usage Examples
The following example configures the SROS to dial 704-555-1212 (digital 64 kbps connection) to initiate
backup operation for this endpoint using the configured ppp 1 backup interface:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#backup number 7045551212 digital-64k 1 1 ppp 1
5991-2114
Specifies the phone number to call when the backup is initiated.
Indicates number connects to an analog modem.
Indicates number belongs to a digital 56 kbps per DS0 connection.
Indicates number belongs to a digital 64 kbps per DS0 connection.
Specifies the minimum number of DS0s required for a digital 56 or 64 kbps
connection (Range: 1 to 24).
Specifies the maximum number of DS0s desired for a digital 56 or 64 kbps
connection (Range: 1 to 24).
Specifies the PPP interface to use as the backup for this interface.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
730