HP ProCurve 7102dl Reference Manual page 70

SROS Command Line Interface Reference Guide
copy cflash
Use the copy cflash command to copy file located on the compact flash card to a specified destination.
Variations of this command include:
copy cflash <filename> cflash <filename>
copy cflash <filename> flash <filename>
copy cflash <filename> interface <type> <slot/port>
copy cflash <filename> startup-config
copy cflash <filename> tftp
copy cflash <filename> xmodem
Syntax Description
<filename>
cflash <filename>
flash <filename>
startup-config
tftp
xmodem
Default Values
No default value necessary for this command.
Usage Examples
The following example copies the file myfile.biz (located on the compact flash card) to flash memory
(naming the new file newfile.biz):
ProCurve>enable
ProCurve#copy cflash myfile.biz flash newfile.biz
5991-2114
Specifies the name of the file (located on the compact flash card) to copy. The
asterisk (*) can be used as a wildcard to specify a pattern for erasing multiple
files. When a wildcard is specified, only files matching the listed pattern are
copied. When using a wildcard, leave the destination filename blank because
the source files are copied identically (including the filename) to the
destination. You cannot use a wildcard when the destination is
startup-config.
Specifies the destination memory location for the file copy as compact flash
memory and specifies the filename.
Specifies the destination memory location for the file copy as flash memory
and specifies the filename.
Replaces the primary startup-configuration file with a copy of the specified file.
Specifies sending the file using the trivial file transfer protocol (TFTP). After
entering copy cflash XXXX tftp, the SROS prompts for the following
information:
Address of remote host:
Destination filename:
Sends the specified file (using the XMODEM protocol) to the terminal
connected to the Console port.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
Specifies the IP address of the TFTP server.
Specifies the filename to use when storing the
copied file on the TFTP server. (The file will be
placed in the default directory established by
the TFTP server.)
68