HP ProCurve 7102dl Reference Manual page 80

SROS Command Line Interface Reference Guide
copy tftp <destination>
Use the copy tftp command to copy a file located on a network Trivial File Transfer Protocol (TFTP)
server to a specified destination.
Syntax Description
<destination>
Address of remote host:
Source filename:
Destination filename:
Default Values
No default value necessary for this command.
Usage Examples
The following example replaces the current running-configuration file with new_config.txt from the TFTP
server (10.200.2.4):
ProCurve#copy tftp running-config
Address of remote host?10.200.2.4
Source filename new_config.txt
Initiating TFTP transfer...
Received 4562 bytes.
Transfer Complete!
ProCurve#
The following example copies the file J03_01.biz from the TFTP server (10.200.2.4) and saves it compact
flash memory (naming the copy SROS.BIZ):
ProCurve#copy tftp cflash
Address of remote host?10.200.2.4
Source filename J03_01.biz
Destination filename SROS.BIZ
Initiating TFTP transfer...
Received 45647 bytes.
Transfer Complete!
ProCurve#
5991-2114
Specifies the destination of the file copied from the TFTP server.
Valid destinations include: cflash (installed compact flash card), flash (flash
memory), startup-config (the primary configuration file), or running-config
(the current running configuration file).
After entering copy tftp and specifying a destination, the SROS prompts for
the following information:
Specifies the IP address of the TFTP server.
Specifies the Name of the file to copy from the TFTP server.
Specifies the filename to use when storing the copied file to flash memory.
(Valid only for the copy tftp cflash and copy tftp flash commands.)
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
78