HP ProCurve 7102dl Reference Manual page 216

SROS Command Line Interface Reference Guide
show ip igmp interface <interface>
Use the show ip igmp interface command to display multicast-related information per-interface. If no
interface is specified, this command shows information for all interfaces.
Syntax Description
<interface>
Default Values
No default value necessary for this command.
Usage Examples
The following is sample output from this command:
ProCurve>enable
ProCurve#show ip igmp interface
eth 0/1 is UP
Ip Address is 10.22.120.47, netmask is 255.255.255.0
IGMP is enabled on interface
Current IGMP version is 2
IGMP query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP max query response time is 10 seconds
Last member query count is 2
Last member query response interval is 1000 ms
IGMP activity: 548 joins, 0 leaves
IGMP querying router is 0.0.0.0
IGMP helper address is disabled
5991-2114
Optional. Designates the display of information for a specific interface (in the format
type slot/port). Enter the show ip igmp interface ? command for a complete list of
interfaces.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
214