Troubleshooting Port Security; Cannot Set The Port Security Mode; Cannot Configure Secure Mac Addresses - HP A6600 Configuration Manual

1. Authenticated user : MAC address: 0002-0000-0011
Controlled User(s) amount to 1
In addition, as NTK is enabled, frames with unknown destination MAC addresses, multicast addresses,
and broadcast addresses should be discarded.

Troubleshooting port security

Cannot set the port security mode

Symptom
Cannot set the port security mode.
[Router-GigabitEthernet1/0/1] port-security port-mode autolearn
Error:When we change port-mode, we should first change it to noRestrictions, then change
it to the other.
Analysis
For a port operating in a port security mode other than noRestrictions, you cannot change the port
security mode by using port-security port-mode directly.
Solution
Set the port security mode to noRestrictions first.
[Router-GigabitEthernet1/0/1] undo port-security port-mode
[Router-GigabitEthernet1/0/1] port-security port-mode autolearn

Cannot configure secure MAC addresses

Symptom
Cannot configure secure MAC addresses.
[Router-GigabitEthernet1/0/1] port-security mac-address security 1-1-2 vlan 1
Error: Security MAC address configuration failed.
Error:Can not operate security MAC address for current port mode is not autoLearn!
Analysis
No secure MAC address can be configured on a port operating in a port security mode other than
autoLearn.
Solution
Set the port security mode to autoLearn.
[Router-GigabitEthernet1/0/1] undo port-security port-mode
[Router-GigabitEthernet1/0/1] port-security max-mac-count 64
[Router-GigabitEthernet1/0/1] port-security port-mode autolearn
[Router-GigabitEthernet1/0/1] port-security mac-address security 1-1-2 vlan 1
193