Configuring Three-Party Conference In Active Participation Mode By Using Command Lines - HP FlexNetwork MSR Series Configuration Manual

To configure three-party conference in active participation mode on a telephone:
Enable keys
*34#
Configuring three-party conference in active participation
mode by using command lines
Step
1. Enter system view.
2. Enter voice subscriber line
view.
3. Enable three-party
conference in active
participation mode.
For the detailed configuration example, see
Configuring calling party control
This section describes the procedure for enabling and configuring calling party control.
Configuration prerequisites
The router is equipped with an FXS voice interface card.
Configuring calling party control
Step
1. Enter system view.
2. Enter voice subscriber line
view.
3. Enable calling party control
and set the on-hook delay
time of the called party.
Configuring door opening control
This section describes the procedure for enabling and configuring door opening control.
Configuration prerequisites
Install an SIC audio card on the device on which the door opening-enabled FXS voice subscriber line
resides.
Disable keys
#34#
Command
system-view
subscriber-line line-number
joined-conference enable
"Silent monitor and barge
Command
system-view
subscriber-line line-number
timer called-hookon-delay
seconds
244
Remarks
N/A
N/A
Disabled by default.
in."
Remarks
N/A
N/A
Calling party control is disabled by
default, that is, the on-hook delay
of the called party is set to 0.