NEC Univerge sv8500 Manual page 1378

14.4.10 DELETE Command
1. DELETE Δ VLAN Δ
This command is used to delete VLAN. To make this assignment effective, it is required to execute the
"SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>DELETE VLAN 1
VLAN deleting succeeded.
14.4.11 SAVE Command
1. SAVE Δ CONFIGDATA
This command is used to save the configuration data.
MG-PRI(SIP)>SAVE CONFIGDATA
** Don't power off in progress **
Do you need save? [Y/N]: Y
Erase start...
Erase OK!
Write start...
Write OK!
Configuration data has been saved.
Re-starting is required for making a setup reflect!!
14.4.12 GET Command
1. GET Δ CONFIGDATA
This command is used to download configuration data from TFTP server.
MG-PRI(SIP)>GET CONFIGDATA 10.10.10.10
The download of configuration data was successful.
P1
Δ P1
VOL.2-1125
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
P1-Specify VLAN ID
Result is displayed.
Y: The data is saved
N: The data is not saved
Result is displayed.
P1-Specify the IP address of TFTP
server after the command name.
Result is displayed.