Match Ip Precedence - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

match ip precedence

Use IP precedence values as a match criteria.

C-Series, E-Series, S-Series, Z-Series, S4810

match ip precedence ip-precedence-list [[multicast] set-ip-dscp

To remove IP precedence as a match criteria, use the no match ip precedence ip-

precedence-list [[multicast] set-ip-dscp value] command.

ip-precedence-

Command Modes

CLASS-MAP CONFIGURATION (config-class-map)

Command History

Version 8.3.11.1

Version 8.3.7.0

Version 7.7.1.0

Version 7.6.1.0

Version 7.5.1.0

You must enter the class-map command in order to access this command. After the class

map is identified, you can configure the match criteria.

– identifies the class map.

Enter the IP precedence value(s) as the match criteria. Separate

values by commas — no spaces ( 1,2,3 ) or indicate a list of values

separated by a hyphen (1-3). The range is 0 to 7.

(OPTIONAL) Enter the keyword multicast to match against

multicast traffic.

NOTE: This option is not supported on the C-Series or S-Series.

(OPTIONAL) Enter the keywords set-ip-dscp followed by the IP

DSCP value. The matched traffic is marked with the DSCP value. The

range is 0 to 63.

Introduced on the Z9000.

Introduced on the S4810.

Added the keyword multicast. Added support for the DSCP

marking option for the S-Series.

Introduced on the S-Series.

Introduced on the C-Series.

Added support for the DSCP Marking option.

Introduced on the E-Series.