Match Ip6Flowlbl; Match Ip Dscp - Dell Networking 7048 Reference Manual

match ip6flowlbl

The match ip6flowlbl command adds to the specified class definition a
match condition based on the IPv6 flow label of a packet.
Syntax
match ip6flowlbl
label - The value to match in the Flow Label field of the IPv6 header
•
(Range 0-1048575).
Default Configuration
There is no default configuration for this command.
Command Mode
Ipv6-Class-Map Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example adds a rule to match packets whose IPv6 Flow Label
equals 32312.
console(config-classmap)#match ip6flowlbl 32312

match ip dscp

Use the match ip dscp command in Class-Map Configuration mode to add to
the specified class definition a match condition based on the value of the IP
DiffServ Code Point (DSCP) field in a packet. This field is defined as the
high-order six bits of the Service Type octet in the IP header. The low-order
two bits are not checked.
Syntax
dscpval
match ip dscp
label
QoS Commands
685