Initial Configuration Of The E1/T1 Card; Configure Basic Parameters Through Command Line Interface - Avaya Communication Server 1000 Installation And Commissioning Manual

Initial configuration of the E1/T1 card

Configure basic parameters through command line interface

Follow Configuring basic parameters through CLI
parameters.
Configuring basic parameters through CLI
1. Connect to the CLI through RS-232. Make sure the CLI screen is active.
2. Power up the system.
3. Enter the LAN settings. For detailed information, see
4. Verify the network connections. For detailed information, see
Power up the system
When you first install and power up the PRI Gateway, the E1/T1 banner appears on the window.
See Figure 20: General status display
enabled spans. After the first power-up, the banner parameters are empty.
The window displays the following information:
• logo
• customer-defined card name
• status of the E1/T1 spans
• IP address
The window displays one line for each E1/T1 span.
Media Gateway 1000E PRI Gateway Installation and Commissioning
SSCK 1 s
Important:
The E1/T1 card ignores all RS-232 control signals, so a modem eliminator (null
modem) is required as shown in
page 105.
connections on page 106.
Initial configuration of the E1/T1 card
on page 103 to configure the basic
Figure 24: Modem connection
on page 104 which displays an example of three
on page 108.
Configure LAN parameters
Verify network
March 2013
on
103