Lldp Commands; Introduction - Allied Telesis IE220 Series Manual

52

Introduction

Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the
Allied Telesis Enterprise MIBs in AlliedWare
The Voice VLAN feature can be configured using commands in
chapter.
For more information about LLDP, see the
Configuration
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List •
•
•
•
•
•
•
•
•
•
•
C613-50644-01 Rev B

LLDP Commands

Guide.
SNMP Feature Overview and Configuration
"clear lldp statistics" on page 2195
"clear lldp table" on page 2196
"debug lldp" on page 2197
"lldp faststart-count" on page 2199
"lldp holdtime-multiplier" on page 2200
"lldp management-address" on page 2201
"lldp med-notifications" on page 2202
"lldp med-tlv-select" on page 2203
"lldp non-strict-med-tlv-order-check" on page 2206
"lldp notification-interval" on page 2207
"lldp notifications" on page 2208
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Plus).
VLAN Commands
LLDP Feature Overview and
Guide).
Support for
2193