Table 92: Show L2Tp Tunnel Output Fields - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Copyright © 2010, Juniper Networks, Inc.

Table 92: show l2tp tunnel Output Fields

Field Name
Configuration
Administrative state
SNMP traps
Tunnel address
Transport
Virtual router
Local and peer addresses
Local and peer UDP ports
Tunnel status
Effective administrative state
State
Local and peer tunnel id
Chapter 16: Monitoring L2TP and L2TP Dial-Out
Field Description
Configured status of the tunnel enabled
Administrative status of the enabled tunnel:
enabled—No restrictions on creation and operation
of sessions for this tunnel
disabled—Router disabled existing sessions and
will not create new sessions on this tunnel
drain—Router will not create new sessions on this
tunnel
Whether or not the router sends traps to SNMP for
operational state changes
Tunnel address information.
Method used to transfer traffic
Name of the virtual router on which the tunnel is
configured
IP addresses of the local and remote ends of the
tunnel. If the router is set up to ignore address and
port changes in SCCRP packets, both the transmit
and receive addresses are listed for the peer.
UDP ports for the local and remote ends of the tunnel.
If the router is set up to accept address and port
changes in SCCRP packets, both the transmit and
receive UDP ports are listed for the peer.
Tunnel status information.
Most restrictive of the following administrative states:
E Series router, destination, and tunnel. This setting,
rather than the administrative state of the tunnel,
determines whether the router can create new
sessions on a tunnel or whether the sessions on a
tunnel are disabled or not.
Status of the enabled tunnel:
idle
connecting
established
disconnecting
Names the router used to identify the tunnel locally
and remotely
435