Shift Cover - SSANGYONG Rexton Y200 Manual

Hide thumbs Also See for Rexton Y200:

Table of Contents

SSANGYONG Y200

MANUAL TRANSMISSION 5B-41

Assembly Procedure

1. Install the O-ring and steel ring to the rear of the

extension housing.

2. Install the vent to the extension housing.

SHIFT COVER

Disassembly Procedure

1. Using a hammer and a pin punch (3/16) remove

the selector arm roll pin.

2. Before removal, note the correct position of the

interlock plate and selector arm and remove the

shift shaft.

3. Check and clean all removed parts and replace if

Assembly Procedure

1. If the shaft cup plug was removed, apply plug

outer surface with sealer and install it into the

2. Install the fork pads and selector plates onto the

1-2 and 3-4 shift forks.

3. Assemble the sift cover parts as follows :

Push the shift shaft into the cover until the front

of the shaft is at the inside of the cover.

Table of Contents