SSANGYONG Rexton Y200 Manual page 1118

5B-32 MANUAL TRANSMISSION
12. Align the slots of the lever with the rollers of the
reverse fork and 5th shift rail. Apply sealer on the
5-R lever pivot bolt and install it into the case.
Installation Notice
Tightening Torque
13. Using a needle nose pliers, install the 5-R lever
clip.
YAD5B780
14. Using a needle nose pliers, install the reverse fork
spring to its pin inside the case. Check the
operation of the 5-R shift mechanism at this time.
YAD5B790
15. Using a snap ring piers, install the slip yoke snap
ring onto the end of the main shaft.
16. Make sure that the 1-2 and 3-4 synchronizer
sleeves and 5-R shift lever are in neutral position.
YAD5B800
17. Align the holes the case and cover with alignment-
type bolts. Tighten the 10 bolts.
Installation Notice
Tightening Torque
18. Apply RTV sealant on the sealing surface of the
extension housing.
19. Apply grease on the detent/guide plate in the
extension housing. Install the detent ball in the 3-
4 position.
YAD5B810
28 N•m (21 lb-ft)
15 N•m (11 lb-ft)
SSANGYONG Y200