Toyota Tundra 2005 Service - Repair - Maintenance page 2366

TRANSFER − TRANSFER ASSEMBLY
5. INSTALL LOW GEAR SPLINE PIECE
(a) Install the low gear spline piece.
TF0473
(b) Using a screwdriver, install the snap ring.
NOTICE:
Make sure the end gap of the snap ring is not aligned with
the cutout portion of the planetary carrier.
TF0472
6. INSTALL PLANETARY GEAR ASSEMBLY WITH INPUT
SHAFT ASSEMBLY
(a) Install the planetary gear assembly with the input shaft
assembly.
HINT:
If necessary, heat the front case to about 50 to 80 °C (122 to
176 °F).
Q07221
(b) Using a snap ring expander, install the snap ring.
HINT:
Check that the planetary gear and input shaft assembly turn
slightly.
7. INSTALL OIL PUMP DRIVE GEAR
Q07220
8. INSTALL OIL PUMP BODY ASSEMBLY
Install the oil pump body assembly with the 3 bolts.
Torque: 7.5 N·m (76 kgf·cm, 66 in.·lbf)
Q07218
TR−17