Toyota Tundra 2005 Service - Repair - Maintenance page 2359

TR−10
TRANSFER − TRANSFER ASSEMBLY
(c) Mount the rear case in a vise.
(d) Using a plastic hammer, carefully tap the rear case, and
remove the rear output shaft assembly, driven sprocket
assembly, chain and front drive and high and low shift
forks as an assembly.
(e) Remove the driven sprocket assembly, chain and front
drive and high and low shift forks from the rear output
shaft assembly.
F07969
12. REMOVE ACTUATOR ASSEMBLY
(a) Using 2 screwdrivers and a hammer, remove the snap
ring.
(b) Remove the 3 bolts and actuator assembly.
F07970
(c) Remove the O−ring, transfer 4WD position switch, trans-
fer L4 position switch and 2 gaskets from the actuator as-
sembly.
F07971
13. REMOVE SEPARATOR WITH OIL STRAINER AND
MAGNET
Remove the 3 bolts and separator with the oil strainer and mag-
net.
D03238
14. REMOVE OIL PUMP BODY ASSEMBLY
Remove the 3 bolts and oil pump body assembly.
15. REMOVE OIL PUMP DRIVE GEAR
Q07218