Toyota Tundra 2005 Service - Repair - Maintenance page 2354

Oil Level
Filler Plug
0 to 5 mm
(0 to 0.20 in.)
Drain Plug
TRANSFER − TRANSFER UNIT
INSTALLATION
1. RAISE VEHICLE
2. INSTALL TRANSFER
Raise the transfer and install it to the transfer adaptor with the
8 transfer mounting bolts and clamps.
Torque: 24 N·m (244 kgf·cm, 17 ft·lbf)
NOTICE:
Take care not to damage the lip of the transfer adaptor rear
oil seal with the transfer input shaft.
3. CONNECT TRANSFER DETECTION SWITCHES AND
MOTOR ACTUATOR CONNECTORS
(See page TR−3)
F08000
4. INSTALL ENGINE REAR MOUNTING
Install the engine rear mounting to the transfer adaptor with the
4 bolts.
Torque: 65 N·m (664 kgf·cm, 48 ft·lbf)
5. INSTALL CROSSMEMBER
(a) Install the crossmember with the 4 bolts and nuts.
Torque: 72 N·m (740 kgf·cm, 53 ft·lbf)
(b) Install the 4 bolts.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
F07999
(c) Remove the transmission jacks.
(d) Install the heat insulator with the 2 bolts
Torque: 16 N·m (163 kgf·cm, 12 ft·lbf)
6. INSTALL FRONT AND REAR PROPELLER SHAFTS
(See page PR−15)
7. INSTALL LH AND RH FRONT EXHAUST PIPES
(See page EM−127)
8. FILL TRANSFER OIL
Oil grade: API GL−4 or GL−5
Viscosity: SAE 75W−90
Capacity: 1.0 liters (1.1 US qts, 0.9 lmp. qts)
Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)
9. CONNECT BREATHER HOSE
Connect the breather hose to the transfer.
Hose installation depth: 13 mm (0.51 in.) or more
10. DO ROAD TEST
F03750
Check for abnormal noises and smooth shifting.
TR−5
TR09I−03