Toyota Tundra 2005 Service - Repair - Maintenance page 2356

TRANSFER −
DISASSEMBLY
1. REMOVE SPEEDOMETER DRIVEN GEAR HOLE COV-
ER
(a) Remove the bolt and speedometer driven gear hole cov-
er.
(b) Remove the O−ring from the speedometer driven gear
hole cover.
2. REMOVE PROTECTOR
Remove the 4 bolts and protector.
3. REMOVE FRONT BEARING RETAINER
(a) Remove the 5 bolts.
(b) Using a plastic hammer, tap on the front bearing retainer
and remove it.
4. REMOVE UPPER COVER AND OIL DEFLECTOR
Remove the 4 bolts, upper cover and oil deflector.
F07962
5. REMOVE FRONT COMPANION FLANGE
(a) Using a chisel and hammer, loosen the staked part of the
front companion flange lock nut.
(b) Using SST, hold the front companion flange and remove
SST
the front companion flange lock nut.
SST
Q07159
(c) Using SST, remove the front companion flange.
SST
6. REMOVE REAR COMPANION FLANGE
Remove the rear companion flange in the same way as the front
companion flange.
SST
F07963
7. REMOVE EXTENSION HOUSING
(a) Remove the 5 bolts.
(b) Using a plastic hammer, tap on the extension housing and
remove it.
8. REMOVE VEHICLE SPEED SENSOR DRIVE GEAR
(a) Remove the 2 output washers and vehicle speed sensor
drive gear.
(b) Using a magnetic finger, remove the ball from the rear out-
put shaft.
F07964
TRANSFER ASSEMBLY
09330−00021
09950−40011 (09951−04020, 09952−04010,
09953−04030, 09954−04010, 09955−04051,
09957−04010, 09958−04011)
TR−7
TR09K−03