Toyota Tundra 2005 Service - Repair - Maintenance page 2358

High and Low
Shift Fork
Snap Ring
Shift Fork Shaft
TRANSFER
(d)
Front Drive
Shift Fork
(e)
Snap Ring
F07979
(f)
F07980
11.
(a)
HINT:
Remove only the snap ring on the front side of the shift fork
shaft.
F07967
(b)
F07968
− TRANSFER ASSEMBLY
To pull out the shift fork shaft, shift the front drive and high
and low shift forks to the positions as shown in the illustra-
tion.
Pull out the shift fork shaft.
Using a magnetic finger, remove the 2 straight pins from
the front drive and high and low shift forks.
REMOVE REAR OUTPUT SHAFT ASSEMBLY, DRIVEN
SPROCKET ASSEMBLY, CHAIN AND FRONT DRIVE
AND HIGH AND LOW SHIFT FORKS
Using 2 screwdrivers and a hammer, tap out the snap ring
from the shift fork shaft of the actuator assembly.
Using a snap ring expander, remove the snap ring.
TR−9