Error-Diffusion Restraint Config - HP MSR series Command Reference Manual

Receiver alarm state is None.
Historical Statistics:
Last clearing of counters: Never
Data in current interval (150 seconds elapsed):
0 Loss Frame Alignment Secs, 0 Framing Error Secs,
0 CRC Error Secs, 0 Alarm Indication Secs, 0 Loss-of-signals Secs,
0 Code Violations Secs, 0 Slip Secs, 0 E-Bit error Secs.
Table 21 Command output
Field
E1 2/0 current state: UP
Description : E1 2/0 Interface
Work mode
Cable type
Frame-format
Source Clock
Line Code
Idle Code
Itf type
Itf number
Loopback
Alarm State
Historical Statistics
Last clearing of counters
Data in current interval (150 seconds
elapsed):
0 Loss Frame Alignment Secs, 0
Framing Error Secs,
0 CRC Error Secs, 0 Alarm Indication
Secs, 0 Loss-of-signals Secs,
0 Code Violations Secs, 0 Slip Secs, 0
E-Bit error Secs

error-diffusion restraint config

Use error-diffusion restraint config to set the three parameters in error packets diffusion restraint.
Use undo error-diffusion restraint config to restore the default values of the three parameters.
Syntax
error-diffusion restraint config detect-timer renew-timer threshold
undo error-diffusion restraint config
Description
State of the interface.
Description of the interface.
Operating mode of the interface, which can be E1 or CE1.
Cable type of the interface.
Frame format of the interface, which can be CRC4 or non-CRC4.
Operating mode of the source clock of the interface, which can be
master or slave.
Line code, which can be AMI or HDB3.
Idle code, which can be 0x7E or 0xFF.
Interframe filling tag, which can be 0x7E or 0xFF.
Number of interframe filling tags between two successive frames.
Loopback state.
Alarm state.
Statistics on the interface.
The last time when statistics on the interface was cleared.
Error statistics in the current interval.
127