Trace/ Detector - Keysight x-series User Reference Manual

8 Frequency Scan Measurement

Trace/ Detector

Trace/ Detector
Displays the menu keys that enable you to control the trace setting.
Key Path
Notes
Initial S/W Revision
Select Trace
Specifies the selected trace. The "selected trace" is the trace that other parameters under the
Trace/Detector menu will apply to.
Key Path
Notes
Preset
State Saved
Initial S/W Revision
Clear Write
In Clear Write type each trace update replaces the old data in the trace with new data. When Clear Write
is pressed for one trace, the data for that trace will be cleared.
Key Path
Example
Dependencies
Couplings
Preset
State Saved
Initial S/W Revision
Trace Average
In Trace Average type the analyzer maintains and displays an average trace, which represents the
cumulative average on a point-by-point basis of the new trace data and previous averaged trace data.
578
Front-panel key
Front panel only.
A.07.00
Trace/ Detector
Front panel only. The selected trace is remembered even when not in the Trace/ Det Menu.
Trace 1.
Saved in instrument state.
A.07.00
Trace/Detector
TRAC:FSC:TYPE WRIT
This key is grayed out when a scan sequence is running except during single range scanning. If the
grayed out key is pressed, an advisory message is generated. If the equivalent SCPI command is sent,
this same message is generated as part of a "–221, Settings conflict" warning.
Whenever you press Clear Write or send the equivalent remote command,
Update is set to On and Display is set to On.
After a Preset, any trace that is in Trace Average is cleared (all trace points set to mintracevalue).
Saved in instrument state.
A.07.00
EMI Receiver Mode Reference