Mark Signal - Keysight x-series User Reference Manual

10 Monitor Spectrum Measurement
Meas Setup
Key Path
Notes
Dependencies
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision

Mark Signal

Marks the selected signal.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
Mark Duplicates
This menu enables you to mark the signals that are duplicates. A signal is considered to be a duplicate if it
is within the width of the 3 dB RBW value. Signals cannot be duplicate unless they are measured using the
same 3 dB RBW.
Key Path
Initial S/W Revision
All
Marks all duplicate signals.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
782
Meas Setup, Signal List, Mark Signals
Front panel only.
Yes
When the signal list is cleared, this value will reset to 0.
If the signal list is empty, =0
If the signal list is not empty, = number of peaks in signal list table
Saved in instrument state
0
Number of peaks in signal list table.
A.13.00
Meas Setup, Signal List, Mark Signals
:CALCulate:SLISt:MARK:SIGNal <integer>
CALC:SLIS:MARK:SIGN 4 Mark signal #4.
If the signal list contains no data, an error is generated and this function cannot be performed.
If the selected signal is not in the list, an error is generated and this function cannot be performed.
A.13.00
Meas Setup, Signal List, Mark Signals
A.13.00
Meas Setup, Signal List, Mark Signals, Mark Duplicates
:CALCulate:SLISt:MARK:DUPLicates[:ALL]
CALC:SLIS:MARK:DUPL
If the signal list contains no data, an error is generated and this function cannot be performed.
A.13.00
EMI Receiver Mode Reference