Rf Input Port - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Meas Setup
Remote Command
Example
Dependencies
Preset
State Saved
Backwards
Compatibility SCPI
Backwards Compatibility
SCPI Notes
Initial S/W Revision

RF Input Port

Selects the RF Input of the selected range.
Key Path
Remote Command
Example
Dependencies
Preset
State Saved
Range
Initial S/W Revision
Remote Command
468
[:SENSe]:FSCan:SCAN[1]|2|...|10:POWer:GAIN:AUTO ON|OFF|1|0
[:SENSe]:FSCan:SCAN[1]|2|...|10:POWer:GAIN:AUTO?
FSC:SCAN4:POW:GAIN:AUTO ON Turn on Auto preamp for Range 4
FSC:SCAN4:POW:GAIN:AUTO?
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
OFF
Saved in instrument state.
:SENSe1|SENSe2:SCAN[1]|2|...|10:INPut:GAIN:AUTO
[:SENSe]:SCAN[1]|2|...|10:INPut:GAIN:AUTO
This command above is included for ESU compatibility. The suffix [1]|2 and [1]|2|...|10 are irrelevant to
the measurement, they are added solely for remote language compatibility.
A.07.00
Meas Setup, Scan Table
[:SENSe]:FSCan:SCAN[1]|2|...|10:FEED:RF:PORT[:INPut] RFIN | RFIN2
[:SENSe]:FSCan:SCAN[1]|2|...|10:FEED:RF:PORT[:INPut]?
:FSC:SCAN3:FEED:RF:PORT INP2 Set Range 3 to use RF Input port2.
:FSC:SCAN3:FEED:RF:PORT?
This key is available only when the measurement is running on a N9038A.
This key is grayed out during multi range scanning. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict; Function not available while running multirange scan" warning.
This key is grayed out during final measurement. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
RFIN
Saved in instrument state.
RF Input|RF Input 2
A.07.00
:SENSe1|SENSe2:SCAN[1]|2|...|10:INPut:TYPE INPUT1|INPUT2
[:SENSe]:SCAN[1]|2|...|10:INPut:TYPE
:SENSe1|SENSe2:SCAN[1]|2|...|10:INPut:TYPE?
EMI Receiver Mode Reference