Meas Setup - Keysight x-series User Reference Manual

11 APD Measurement

Meas Setup

Meas Setup
Displays a menu of keys that enable you to set up the measurement.
Key Path
Notes
Initial S/W Revision
Select Signal
Specifies the selected signal. The term "Selected signal" is used throughout this document to specify
which signal will be affected by the functions.
Key Path
Notes
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision
Meas Time
Specifies the measurement time for each sweep.
Key Path
Remote Command
Example
Preset
State Saved
Min
Max
Default Unit
Initial S/W Revision
940
Front-panel key
Front panel only.
A.13.00
Meas Setup, Signal List
Front panel only. When Select Signal is the active function, press UP to go up in the signal list, and
press DOWN to go down in the list.
When the signal list is cleared, this value will reset to 0. Select Signal is auto coupled with
Frequency Scan and Monitor Spectrum Selected signal.
If the signal list is empty, =0
If the signal list is not empty, = number of peaks in the signal list table
Saved in instrument state.
0
Number of peaks in the signal list table.
A.13.00
Mode Setup
[:SENSe]:APD:SWEep:TIME <time>
[:SENSe]:APD:SWEep:TIME?
APD:SWE:TIME 500ms
APD:SWE:TIME?
100 ms
Saved in instrument state.
10 ms
120 s
s
A.13.00
EMI Receiver Mode Reference