Limit - Keysight x-series User Reference Manual

19.46919986
19.56330081
19.65740176
19.75150272
19.84560367
19.93969699
20.03379794
20.1278989
20.22199985
20.3161008

Limit

Pressing this key selects Limit Lines as the data type to be exported. Pressing the key a second time brings
up the Limit Menu that allows you to select which Limit Line to save. However, currently there is only 1 limit
line for the APD measurement.
Key Path
Remote Command
Example
Notes
Dependencies
Preset
State Saved
Readback
Status Bits/OPC
dependencies
Initial S/W Revision
APD Limit File Content
The following file example shows the Limit file content in comma separated values when the APD Method
is set to:
(a)Disturbance Level
Limit
EMI Receiver Mode Reference
0.638484031
0.632386608
0.626085183
0.619035746
0.612008976
0.604778203
0.598635447
0.592334021
0.585579255
0.578461817
Save, Data
:MMEMory:STORe:ALIMit LLINE1,<filename>
:MMEM:STOR:ALIM LLINE1, " myAPDLimit.csv" saves the Limit Line to the file myAPDLimit.csv in
the current path. The default path is My Documents\EMI\data\APD\Limits.
If the save is initiated via SCPI, and the file already exists, the file will be overwritten.
Using the C: drive is strongly discouraged, since it runs the risk of being overwritten during an
instrument software upgrade.
Both single and double quotes are supported for any filename parameter over SCPI.
This key will only appear if you have the proper option installed in your instrument.
1; not part of Preset, but is reset by Restore Mode Defaults and survives power cycles.
The selected Limit number is saved in instrument state.
Selected Limit Line
Sequential - waits for previous measurement to complete
A.13.00
11 APD Measurement
Save
991