Sweep/Control - Keysight x-series User Reference Manual

Sweep/Control

Displays the menu keys that enable you to control the sweep parameters.
Key Path
Notes
Initial S/W Revision
Pause/Resume
Pauses the automated APD measurement that is initiated by the Start Measure key after the current data
acquisition is complete. When paused, the label on the key changes to "Resume". Pressing the Resume
key resumes the measurement at the point it was at when paused.
Key Path
Remote Command
Example
Dependencies
Couplings
Initial S/W Revision
Key Path
Remote Command
Example
Dependencies
Couplings
Initial S/W Revision
Start Measure/ Stop
When this key is pressed, the analyzer executes an automated APD measurement based on the Measure
selection in the Meas Setup menu, i.e. all signals or mark signals, and then returned.
If the limit table is empty when this key is pressed, a prompt message is placed on the screen that says:
EMI Receiver Mode Reference
Front-panel key
Front panel only.
A.13.00
Sweep/ Control
:INITiate:PAUSe
INIT:PAUS
Pause is not available when the automated APD measurement is not running.
When paused, the label on the key changes to "Resume".
A.13.00
Sweep/ Control
:INITiate:RESume
INIT:RES
Resume is not available when the automated APD measurement is not running.
When resumed, the label on the key changes to "Pause".
A.13.00
11 APD Measurement
Sweep/Control
1005