Wait-To-Continue - Keysight x-series User Reference Manual

3 Programming the Analyzer
IEEE 488.2 Common Commands

Wait-to-Continue

This command causes the instrument to wait until all overlapped commands are completed before
executing any additional commands. There is no query form for the command.
Remote Command
Example
Status Bits/OPC
dependencies
Initial S/W Revision
148
*WAI
INIT:CONT OFF; INIT;*WAI Sets the instrument to single sweep. Starts a sweep and waits for its
completion.
Not global to all remote ports or front panel. *OPC only considers operation that was initiated on the
same port as the *OPC command was issued from.
Prior to A.02.00
EMI Receiver Mode Reference