Questionable Calibration Extended Failure Condition - Keysight x-series User Reference Manual

"Questionable Calibration Extended Failure Positive Transition " on page 122

Questionable Calibration Extended Failure Condition

This query returns the decimal value of the sum of the bits in the Questionable Calibration Extended Failure
Condition register.
The data in this register is continuously updated and reflects the current conditions.
Mode
Remote Command
Example
Preset
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Calibration Extended Failure Enable
This command determines which bits in the Questionable Calibration Extended Failure Condition Register
will set bits in the Questionable Calibration Extended Failure Event register, which also sets bit 9 of the
Questionable Calibration Register. The variable <integer> is the sum of the decimal values of the bits you
want to enable.
Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Calibration Extended Failure Event Query
This query returns the decimal value of the sum of the bits in the Questionable Calibration Extended Failure
Event register.
The register requires that the associated PTR or NTR filters be set before a condition register bit can set a
bit in the event register. The data in this register is latched until it is queried. Once queried, the register is
cleared.
EMI Receiver Mode Reference
All
:STATus:QUEStionable:CALibration:EXTended:FAILure:CONDition?
STAT:QUES:CAL:EXT:FAIL:COND?
0
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle <integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle?
STAT:QUES:CAL:EXT:FAIL:ENAB 1 Can be used to query if an EMI conducted alignment is needed.
32767
0
32767
Sequential command
Prior to A.02.00
3 Programming the Analyzer
STATus Subsystem
121