Trace - Keysight x-series User Reference Manual

11 APD Measurement
Save
• Frequency Interpolation: Logarithmic, Linear

Trace

Pressing this key selects Traces as the data type to be exported. Pressing this key when it is already
selected brings up the Trace Menu, which allows you to select which Trace to save.
Key Path
Remote Command
Example
Notes
Dependencies
Readback
Status Bits/OPC
dependencies
Initial S/W Revision
APD Trace File Content
The following file example shows the Trace file content in Excel for one trace.
Trace
EMI:APD
A.12.50
526 EA3 B25 P26 PFR
Amptd Unit
DATA
Trace1
18.81050082
18.90460178
18.99870273
19.09280368
19.186897
19.28099796
19.37509891
990
Save, Data
:MMEMory:STORe:ATRace MEAS|MEAS2|ELIMit|ALL,<filename>
:MMEM:STOR:ATR MEAS, "MyApdTrace.csv" exports Measured Trace to the file MyApdTrace.csv in
the current path. The default path is My Documents\EMI\data\APD\Traces.
If the save is initiated via SCPI, and the file already exists, the file will be overwritten.
Using the C: drive is strongly discouraged, since it runs the risk of being overwritten during an
instrument software upgrade.
Both single and double quotes are supported for any filename parameter over SCPI.
Traces cannot be recalled from a trace file that was saved with ALL traces selected.
Selected Trace
Sequential - waits for previous measurement to complete
A.13.00
N9038A
1
dBuV
0.677811275
0.672439196
0.666681778
0.661241698
0.65548428
0.650293538
0.644037446
EMI Receiver Mode Reference