Clear Mark - Keysight x-series User Reference Manual

Upper
Marks duplicate signals with higher amplitude.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
Lower
Marks duplicate signals with lower amplitude.
Key Path
Remote Command
Example
Notes
Initial S/W Revision

Clear Mark

Clears mark from the selected signal.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
Mark All
Marks all signals in the signal list.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
EMI Receiver Mode Reference
Meas Setup, Signal List, Mark Signals, Mark Duplicates
:CALCulate:SLISt:MARK:DUPLicates:UPPer
CALC:SLIS:MARK:DUPL:UPP
If the signal list contains no data, an error is generated and this function cannot be performed.
A.13.00
Meas Setup, Signal List, Mark Signals, Mark Duplicates
:CALCulate:SLISt:MARK:DUPLicates:LOWer
CALC:SLIS:MARK:DUPL:LOW
If the signal list contains no data, an error is generated and this function cannot be performed.
A.13.00
Meas Setup, Signal List, Mark Signals
:CALCulate:SLISt:MARK:CLEar:SIGNal <integer>
CALC:SLIS:MARK:CLE:SIGN 11 Clear mark from signal #11.
If the signal list contains no data, an error is generated and this function cannot be performed.
If the selected signal is not in the list, an error is generated and this function cannot be performed.
A.13.00
Meas Setup, Signal List, Mark Signals
:CALCulate:SLISt:MARK:ALL
CALC:SLIS:MARK:ALL
If the signal list contains no data, an error is generated and this function cannot be performed.
A.13.00
10 Monitor Spectrum Measurement
Meas Setup
783