Questionable Calibration Extended Needed Positive Transition - Keysight x-series User Reference Manual

Questionable Calibration Extended Needed Positive Transition

This command determines which bits in the Questionable Calibration Extended Needed Condition register
will set the corresponding bit in the Questionable Calibration Extended Needed Event register when the
condition register bit has a positive transition (0 to 1). The variable <integer> is the sum of the decimal
values of the bits that you want to enable.
Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Frequency Register
"Questionable Frequency Condition " on page 125
"Questionable Frequency Enable " on page 126
"Questionable Frequency Event Query " on page 126
"Questionable Frequency Negative Transition " on page 126
"Questionable Frequency Positive Transition " on page 127
Questionable Frequency Condition
This query returns the decimal value of the sum of the bits in the Questionable Frequency Condition
register.
The data in this register is continuously updated and reflects the current conditions.
Mode
Remote Command
Example
Preset
Status Bits/OPC
dependencies
Initial S/W Revision
EMI Receiver Mode Reference
All
:STATus:QUEStionable:CALibration:EXTended:NEEDed:PTRansition <integer>
:STATus:QUEStionable:CALibration:EXTended:NEEDed:PTRansition?
STAT:QUES:CAL:EXT:NEED:PTR 2 Align EMI conducted is required.
32767
0
32767
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:FREQuency:CONDition?
STAT:QUES:FREQ:COND?
0
Sequential command
Prior to A.02.00
3 Programming the Analyzer
STATus Subsystem
125