Questionable Calibration Event Query - Keysight x-series User Reference Manual

Mode
Remote Command
Example
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision

Questionable Calibration Event Query

This query returns the decimal value of the sum of the bits in the Questionable Calibration Event register.
The register requires that the associated PTR or NTR filters be set before a condition register bit can set a
bit in the event register. The data in this register is latched until it is queried. Once queried, the register is
cleared.
Mode
Remote Command
Example
Preset
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Calibration Negative Transition
This command determines which bits in the Questionable Calibration Condition register will set the
corresponding bit in the Questionable Calibration Event register when the condition register bit has a
negative transition (1 to 0). The variable <integer> is the sum of the decimal values of the bits that you want
to enable.
Mode
Remote Command
Example
Preset
Min
EMI Receiver Mode Reference
All
:STATus:QUEStionable:CALibration:ENABle <integer>
:STATus:QUEStionable:CALibration:ENABle?
STAT:QUES:CAL:ENAB 16384 Can be used to query if an alignment is needed, if you have turned off
the automatic alignment process.
0
32767
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:CALibration[:EVENt]?
STAT:QUES:CAL?
0
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:CALibration:NTRansition <integer>
:STATus:QUEStionable:CALibration:NTRansition?
STAT:QUES:CAL:NTR 16384 Alignment is not required.
0
0
3 Programming the Analyzer
STATus Subsystem
117