Khz Highpass - Keysight x-series User Reference Manual

Initial S/W Revision

150 kHz Highpass

Controls highpass setting on the V-network.
Key Path
Remote Command
Example
Dependencies
Couplings
Preset
State Saved
Range
Initial S/W Revision
V-network
Enables you to select the V-network that is controlled via the AUX IO port.
Key Path
Remote Command
Example
Notes
Preset
State Saved
Initial S/W Revision
EMI Receiver Mode Reference
Only one phase can be selected.
A.13.50
Mode Setup, LISN Control, ENV216
INPut[1]|2:LISN:FILTer:HPAS[:STATe] ON|OFF|1|0
INPut[1]|2:LISN:FILTer:HPAS[:STATe]?
:INP:LISN:FILT:HPAS ON
This key is grayed out when V-network other than ENV216 is selected. If the grayed out key is
pressed, an advisory message is generated. If the equivalent SCPI command is sent, this same
message is generated as part of a "–221, Setting Conflict; Function not available with current LISN
Type" warning.
This key is coupled to 150kHz Highpass of Frequency Scan Measurement's LISN Control (Measure),
and vice versa.
Set to off on a "Restore Input/Output Defaults"
Saved in instrument state
ON|OFF
A.13.50
Mode Setup, LISN Control
INPut[1]|2:LISN[:TYPE] FOURphase|ESH2Z5| ENV216 | OFF
INPut[1]|2:LISN[:TYPE]?
:INP:LISN FOUR
FOURPhase and ESH2-Z5
R&S ESH2-Z5 (four phases and protective earth are controllable)
ENV216
R&S ENV216 (two phases and highpass are controllable)
OFF
Remote control deactivated
This query will return :-
FOUR when ESH2-Z5 is selected.
Set to off on a "Restore Input/Output Defaults"
Saved in instrument state
A.13.50
5 Mode Functions
Mode Setup
263