V-Network - Keysight x-series User Reference Manual

5 Mode Functions
Mode Setup
State Saved
Range
Initial S/W Revision

V-network

Enables you to select the V-network that is controlled via the AUX IO port.
Key Path
Remote Command
Example
Notes
Preset
State Saved
Initial S/W Revision
Phase
This command enables you to select the phase of the V-network that is used, which is controlled via the
AUX IO port. The permissible selection depends on the selected V-network.
Key Path
Remote Command
Example
Couplings
Preset
State Saved
Range
262
Saved in instrument state
GRO|FLO
A.13.50
Mode Setup, LISN Control
INPut[1]|2:LISN[:TYPE] FOURphase|ESH2Z5| ENV216 | OFF
INPut[1]|2:LISN[:TYPE]?
:INP:LISN FOUR
FOURPhase and ESH2-Z5
R&S ESH2-Z5 (four phases and protective earth are controllable)
ENV216
R&S ENV216 (two phases and highpass are controllable)
OFF
Remote control deactivated
This query will return :-
FOUR when ESH2-Z5 is selected.
Set to off on a "Restore Input/Output Defaults"
Saved in instrument state
A.13.50
Mode Setup, LISN Control, ESH2Z5/ENV216
INPut[1]|2:LISN:PHASe L1|L2|L3|N
INPut[1]|2:LISN:PHASe?
:INP:LISN:PHAS L1
Phase N|L1|L2|L3 are grayed out with OFF whereas Phase L2|L3 are grayed out with ENV216. If the
grayed out key is pressed, an advisory message is generated. If the equivalent SCPI command is sent,
this same message is generated as part of a "–221, Setting Conflict; Function not available with
current LISN Type" warning.
Set to N on a "Restore Input/Output Defaults"
Saved in instrument state
Phase N|Phase L1|Phase L2|Phase L3
EMI Receiver Mode Reference