Sort Order - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Meas Setup
By Time
Specifies that the elements in the signal list will be sorted based on time.
Key Path
Example
Initial S/W Revision

Sort Order

Chooses between ascending and descending sort order.
Key Path
Remote Command
Example
Dependencies
Couplings
Preset
State Saved
Initial S/W Revision
Auto Sort
If this is turned on, the measurement will perform signal sorting based on the sorting order and sorting type
selected before each new signal is added. Otherwise, the signal will be added into the signal list in
descending order of the trace amplitude level.
Key Path
Remote Command
Example
Notes
Dependencies
450
Meas Setup, Signal List, Sort Signals
CALC:FSC:SLIS:SORT:TYPE TIME
A.07.00
Meas Setup, Signal List, Sort Signals
:CALCulate:FSCan:SLISt:SORT:ORDer ASCending |DESCending
:CALCulate:FSCan:SLISt:SORT:ORDer?
CALC:FSC:SLIS:SORT:ORD DESC
CALC:FSC:SLIS:SORT:ORD
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
Selecting the sort order (pressing the key or sending the equivalent SCPI command) will turn on the
Auto Sort state, even if that sort order was already selected.
ASCending
Saved in instrument state.
A.07.00
Meas Setup, Signal List, Sort Signals
:CALCulate:FSCan:SLISt:SORT:AUTO ON|OFF|1|0
:CALCulate:FSCan:SLISt:SORT:AUTO?
CALC:FSC:SLIS:SORT:AUTO 1 Turn on auto sorting
CALC:FSC:SLIS:SORT:AUTO?
If Scan Sequence is set to Remeasure, the signal in the list will only be auto sorted when a
Remeasure is completed.
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
EMI Receiver Mode Reference