Questionable Integrity Signal Condition - Keysight x-series User Reference Manual

3 Programming the Analyzer
STATus Subsystem
"Questionable Integrity Signal Enable" on page 130
"Questionable Integrity Signal Event Query" on page 131
"Questionable Integrity Signal Negative Transition" on page 131
"Questionable Integrity Signal Positive Transition" on page 131

Questionable Integrity Signal Condition

This query returns the decimal value of the sum of the bits in the Questionable Integrity Signal Condition
register.
The data in this register is continuously updated and reflects the current conditions.
Mode
Remote Command
Example
Preset
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Integrity Signal Enable
This command determines which bits in the Questionable Integrity Signal Condition Register will set bits in
the Questionable Integrity Signal Event register, which also sets the Integrity Summary bit (bit 9) in the
Questionable Register. The variable <integer> is the sum of the decimal values of the bits you want to
enable.
Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision
130
All
:STATus:QUEStionable:INTegrity:SIGNal:CONDition?
STAT:QUES:INT:SIGN:COND?
0
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:INTegrity:SIGNal:ENABle <integer>
:STATus:QUEStionable:INTegrity:SIGNal:ENABle?
STAT:QUES:INT:SIGN:ENAB 4 Burst Not Found will be reported to the Integrity Summary of the
Status Questionable register.
32767
0
32767
Sequential command
Prior to A.02.00
EMI Receiver Mode Reference