Marker X Axis Value (Remote Command Only) - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Marker

Marker X Axis Value (Remote Command Only)

The command below sets the marker X Axis value in the current marker X Axis Scale unit. In each case the
marker that is addressed becomes the selected marker. It has no effect (other than to cause the marker to
become selected) if the control mode is Off, but it is the SCPI equivalent of entering an X value if the control
mode is Normal orDelta. The command input and query are both in relative values when delta marker is on.
Remote Command
Example
Notes
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision
Marker Y Axis Value (Remote Command Only)
Returns the marker Y Axis value in the current marker Y Axis unit. The query is a relative value when the
delta marker is on.
Remote Command
Example
Notes
Preset
State Saved
Initial S/W Revision
Backwards Compatibility SCPI Commands
"Normal Marker State (Remote Command Only)" on page 415
"Normal Marker X Axis Value (Remote Command Only)" on page 415
414
:CALCulate:FSCan:MARKer[1]|2|...|12:X <real>
:CALCulate:FSCan:MARKer[1]|2|...|12:X?
CALC:FSC:MARK3:X 9e3
CALC:FSC:MARK3:X?
If no suffix is sent, it will use the fundamental units for the current marker X Axis Scale. If a suffix is
sent that does not match the current marker X Axis Scale unit, an "Invalid suffix" error will be
generated.
The query returns the marker's absolute X Axis value if the control mode is Normal, or the offset from
the marker's reference marker, if the control mode is Delta. The query is returned in the fundamental
units for the current marker X Axis scale: seconds. If the marker is off the response is not a number
(NAN).
The Max value is changed by the Dwell Time parameter value.
After a preset, all Markers are turned off, so a Marker X Axis Value query will return not a number
(NaN). When a Marker is on, the default value of the Marker X value is the center of the appropriate
window.
No
–9.9E+37
9.9E+37
A.07.00
:CALCulate:FSCan:MARKer[1]|2|...|12:Y?
CALC:FSC:MARK11:Y? Query marker 11 value.
The query returns the marker Y-axis result. If the marker is Off the response is not a number (NAN).
Trace value at center of screen. There is no way to predict what this will be after a preset.
No
A.07.00
EMI Receiver Mode Reference