Navigate - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Meas Setup
Dependencies
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision

Navigate

This menu enables you to navigate through the signal list without using a mouse.
Key Path
Initial S/W Revision
Page Up
If the signal list fills more than one page, pressing this key moves the signal list up by one page.
Key Path
Notes
Dependencies
Initial S/W Revision
Page Down
If the signal list fills more than one page, pressing this key moves the signal list down by one page.
Key Path
Notes
Dependencies
Initial S/W Revision
440
Yes
When the signal list is cleared, this value will reset to 0.
If the signal list is empty, =0
If the signal list is not empty, = number of peaks in signal list table
Saved in instrument state.
0
Number of peaks in the signal list table.
A.07.00
Meas Setup, Signal List
A.07.00
Meas Setup, Signal List, Navigate
Front panel only.
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
A.07.00
Meas Setup, Signal List, Navigate
Front panel only.
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
A.07.00
EMI Receiver Mode Reference