Gate - Keysight x-series User Reference Manual

4 Input/Output Functions
Input/Output
Key Path
Example
Readback
Initial S/W Revision

Gate

Selects the gate signal to be output to the Trig 1 Out, or Trig 2 Out, connector. The gate signal has been
delayed and its length determined by delay and length settings. When the polarity is positive, a high on the
Trig 1 Out, or Trig 2 Out, represents the time the gate is configured to pass the signal.
Key Path
Example
Readback
Initial S/W Revision
Source Point Trigger
Selects the gate signal to be output to the Trig 1 Out, or Trig 2 Out, connector for use as the Point Trigger
when operating an external source in Tracking mode. When Ext Trigger 1 is selected as the Point Trigger
under Source, the Source Point Trigger under Trig1 Out automatically gets selected. Similarly, when Ext
Trigger 2 is selected as the Point Trigger under Source, the Source Point Trigger key under Trig 2 Out
automatically gets selected
Key Path
Example
Readback
Initial S/W Revision
Odd/Even Trace Point
Selects either the odd or even trace points as the signal to be output to the Trig 1 Out, or Trig 2 Out,
connector when performing swept spectrum analysis. When the polarity is positive, this output goes high
during the time the analyzer is sweeping past the first point (Point 0) and every other following trace point.
The opposite is true if the polarity is negative.
Key Path
Example
Readback
Initial S/W Revision
202
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP GTR
Gate Trigger
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP GATE
Gate
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP SPO
Source Point
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP OEV
Odd/Even
Prior to A.02.00
EMI Receiver Mode Reference