Exit Without Saving - Keysight x-series User Reference Manual

Key Path
Remote Command
Example
Notes
Notes
Initial S/W Revision
Modified at S/W Revision

Exit Without Saving

Pressing this key will exit the Configure Applications utility without saving your changes.
Key Path
Initial S/W Revision
Modified at S/W Revision
Restore Power On Defaults
This selection causes the Power On Type and Power On Application settings to be a reset to their default
values. This level of Restore System Defaults does not affect any other system settings, mode settings and
does not cause a mode switch. The Power On key, under the Restore System Defaults menu, causes the
same action.
EMI Receiver Mode Reference
System, Power On, Configure Applications
:SYSTem:PUP:PROCess
:SYST:PUP:PROC This is the SCPI command for restarting the analyzer. You must Wait after this
command for the instrument application to restart
The softkey will be grayed-out when the virtual memory of the selected applications exceeds 100%
of the limit.
You cannot use *WAI or *OPC? to synchronize operation after a restart. This command stops and
restarts the instrument application, thus the SCPI operation is terminated and restarted. A remote
program must use fixed wait time to resume sending commands to the instrument. The wait time
will be dependent upon which applications are pre-loaded.
A.02.00
A.04.00
System, Power On, Configure Applications
A.02.00
A.04.00
6 System Functions
System
287