Default Directory - Keysight x-series User Reference Manual

Couplings
Readback
Backwards
Compatibility SCPI
Initial S/W Revision

Default Directory

Specifies the default directory used for loading of Amplitude Correction. If user is selected, the default
recall directory is the default (My Documents\amplitudeCorrections) or the last directory you saved the
amplitude correction data to. Otherwise, the default recall directory is My Documents\EMC Limits and
Ampcor\Ampcor, which contains a set of preloaded amplitude correction files in the directory called
Ampcor.
Key Path
Remote Command
Example
Notes
Preset
State Saved
Range
Readback
Initial S/W Revision
Trace
This key selects Trace as the data type to be imported. When pressed a second time, it brings up the Trace
Menu, which lets you select the Trace into which the data will be imported.
The trace file contains "meta" data which describes the state of the analyzer when the trace was exported
(see ). If the meta data in the file does not match the current SA state, the "invalid data indicator" (*) is
displayed.
Key Path
Remote Command
Example
EMI Receiver Mode Reference
When a correction file is loaded from mass storage, it is automatically turned on (Correction ON) and
ApplyCorrections is set to On. This allows you to see its effect, thus confirming the load.
selected Correction
:MMEMory:LOAD:CORRection ANTenna | CABLe | OTHer | USER, <filename>
For backwards compatibility, ANTenna maps to 1, CABle maps to 2, OTHer maps to 3 and USER
maps to 4
A.02.00
Recall, Export Data, Amplitude Correction
:MMEMory:LOAD:CORRection:DDIRectory USER|PRELoaded
:MMEM:LOAD:CORR:DDIR USER Select user
:MMEM:LOAD:CORR:DDIR?
USER = User
PRELoaded = Preloaded
PRELoaded
Saved in instrument state.
User| Preloaded
"User"| "Preloaded"
A.13.00
Recall, Data
:MMEMory:LOAD:TRACe:DATA TRACE1|TRACE2|TRACE3,<filename>
:MMEM:LOAD:TRAC DATA TRACE2, "myTrace2.csv" imports the 2nd trace from the file
9 Strip Chart Measurement
Recall
675