Limit For - Keysight x-series User Reference Manual

Limit for ∆
Selects the limit used by each final detector or measure at marker to get the limit delta value that goes in
the Signal List. If you use the front panel to change the detector type, the following message will appear
to remind you that the change of detector will cause the data of the particular detector type column to be
discarded.
Changing limit for delta will discard the delta values, are you sure you want to do this?
Please press ENTER or OK to proceed. Press ESC or Cancel to close this dialog.
Key Path
Remote Command
Example
Notes
Dependencies
Preset
State Saved
Range
Initial S/W Revision
Autorange (Measure)
Accesses a menu that lets you decide whether or not to turn on the Autorange feature during the final
measurement.
Key Path
Readback
Initial S/W Revision
Autorange
When autorange is selected, the attenuation will be increased automatically when an overload is detected
during the final measurement.
Key Path
Remote Command
Example
EMI Receiver Mode Reference
Meas Setup, Detectors (Measure)
[:SENSe]:FSCan:FINal:DETector[1]|2|3:LDELta <limit Num>
[:SENSe]:FSCan:FINal:DETector[1]|2|3:LDELta?
:FSC:FIN:DET3:LDEL 2 Set limit line 2 to be used by detector 3.
Not affected by Mode Preset, preset by Restore Mode Defaults.
This key is grayed out during final measurement. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
1|1|1
Saved in instrument state.
1|2|3|4|5|6
A.07.00
Meas Setup
In square brackets, the state of Autorange then the state of Auto Preamp, separated by commas, as
[Rng:On, Pre:Off]
A.07.00
Meas Setup, Autorange
[:SENSe]:FSCan:FINal:ATTenuation:AUTO ON|OFF|1|0
[:SENSe]:FSCan:FINal:ATTenuation:AUTO?
:FSC:FIN:ATT:AUTO 0
8 Frequency Scan Measurement
Meas Setup
479