Analog Out - Keysight x-series User Reference Manual

Analog Out

This menu lets you control which signal is fed to the "Analog Out" connector on the analyzer rear panel.
See "More Information" on page 203
Key Path
Remote Command
Example
Preset
Preset
State Saved
Readback line
Backwards Compatibility
Notes
Initial S/W Revision
More Information
The table below gives the range for each output.
Nominal Range
exc.
Analog Out (10% overrange)
Off 0 V
Screen 0 – 1 V open
Video circuit
Log Video 0 – 1 V
terminated
Linear Video 0 – 1 V
terminated
Demod (varies with analyzer setting)
Audio
Auto
Selects the Auto state for the Analog Output menu. In this state, the Analog Output will automatically be
set to the most sensible setting for the current mode or measurement.
EMI Receiver Mode Reference
Input/Output, Output Config
:OUTPut:ANALog OFF|SVIDeo|LOGVideo|LINVideo|DAUDio
:OUTPut:ANALog?
OUTP:ANAL SVIDeo ! causes the analog output type to be Screen Video
This is unaffected by Preset but is set to DAUDio on a "Restore Input/Output Defaults" or "Restore
System Defaults->All
OFF
Saved in Input/Output State
1-of-N selection [variable]
Prior to A.04.00, OFF was the default functionality except when in the Analog Demod application or
with Tune and Listen, in which case it was DAUDio, and there was no selection menu. So for
backwards compatibility with earlier X-Series firmware versions, Auto (:OUTP:ANAL:AUTO ON) will
duplicate the prior behavior.
The DNWB and SANalyzer parameters, which were legal in PSA but perform no function in the X-
Series, are accepted without error.
A.04.00
Scale Factor
10%/division
1/(192.66 dB/V)
100%/V
Notes
8566 compatible
dB referenced to mixer level, 1V out for –10 dBm
at the mixer.
Linear referenced to Ref Level, 1 V out for RF
envelope at the Ref Level.
4 Input/Output Functions
Input/Output
203