Questionable Calibration Positive Transition - Keysight x-series User Reference Manual

3 Programming the Analyzer
STATus Subsystem
Max
Status Bits/OPC
dependencies
Initial S/W Revision

Questionable Calibration Positive Transition

This command determines which bits in the Questionable Calibration Condition register will set the
corresponding bit in the Questionable Calibration Event register when the condition register bit has a
positive transition (0 to 1). The variable <integer> is the sum of the decimal values of the bits that you want
to enable.
Mode
Remote Command
Example
Preset
Min
Max
Status Bits/OPC
dependencies
Initial S/W Revision
Questionable Calibration Skipped Register
"Questionable Calibration Skipped Condition " on page 118
"Questionable Calibration Skipped Enable " on page 119
"Questionable Calibration Skipped Event Query " on page 119
"Questionable Calibration Skipped Negative Transition " on page 120
"Questionable Calibration Skipped Positive Transition " on page 120
Questionable Calibration Skipped Condition
This query returns the decimal value of the sum of the bits in the Questionable Calibration Skipped
Condition register.
The data in this register is continuously updated and reflects the current conditions.
Mode
Remote Command
118
32767
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:CALibration:PTRansition <integer>
:STATus:QUEStionable:CALibration:PTRansition?
STAT:QUES:CAL:PTR 16384 Alignment is required.
32767
0
32767
Sequential command
Prior to A.02.00
All
:STATus:QUEStionable:CALibration:SKIPped:CONDition?
EMI Receiver Mode Reference