Settings - Keysight x-series User Reference Manual

Settings

This menu enables you to access the LISN control menu.
Key Path
ReadBack
Initial S/W Revision
Phase
Selects the phases of the V-network.
Key Path
Remote Command
Example
Notes
Dependencies
Couplings
Preset
State Saved
Range
Initial S/W Revision
150 kHz Highpass
Toggles highpass of the V-network.
Key Path
Remote Command
EMI Receiver Mode Reference
Meas Setup, LISN Control
[<Phase>, <HighPass>, <ProtectiveEarth>] in the format of [N|L1|L2|L3|,HP,GRO|FLO]
HP would be shown when the 150KHz HighPass is turn on. GRO stands for is for grounded and FLO
stands for floating.
A.13.50
Meas Setup, LISN Control, Settings
:SENSe1|SENSe2|[SENSe]:FMEasurement:LISN:PHASe L1 | L2 | L3 | N[[,L1 |
L2 | L3 | N],.]
:SENSe1|SENSe2|[SENSe]:FMEasurement:LISN:PHASe L1 | L2 | L3 | N[[,L1 |
L2 | L3 | N],.]
FME:LISN:PHAS L1
L2 and L3 are only available in ESH2Z5 (or set to FOURphase)
Phase N|L1|L2|L3 are grayed out with OFF whereas Phase L2|L3 are grayed out with ENV216. If the
grayed out key is pressed, an advisory message is generated. If the equivalent SCPI command is sent,
this same message is generated as part of a "–221, Setting Conflict; Function not available with
current LISN Type" warning.
This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a "–221, Settings conflict" warning.
If users try to turn off all available phases from front panel, an advisory message is generated as "At
least one Phase must be turned on".
ON
Saved in instrument state
ON|OFF
ON is selected when the specific phase is selected. User can select different phase at the same time.
A.13.50
Meas Setup, LISN Control, Settings
:SENSe1|SENSe2|[:SENSe]:FMEasurement:LISN:FILTer:HPAS[:STATe] ON | OFF
| 1 | 0
8 Frequency Scan Measurement
Meas Setup
505