Snap To Meters (Select Closest Signal) - Keysight x-series User Reference Manual

8 Frequency Scan Measurement
Marker To
Remote Command
Example
Notes
Couplings
Initial S/W Revision

Snap to Meters (Select Closest Signal)

Changes the selected signal to the closest signal in the Signal List to where the meters frequency is tuned.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
426
:CALCulate:FSCan:SLISt:APPend:METer
CALC:FSC:SLIS:APP:MET Append signal obtained at meters into signal list.
If there is no free space in the signal list, the following prompt message will ask you whether to
continue or not: WARNING! There is not enough free space in Signal List. Would you like to clear the
Signal list before adding signals? Press ENTER to continue or ESC to Cancel.
The appended signal will be the selected signal after a Metersà List is performed.
A.07.00
Marker To
:CALCulate:FSCan:SLISt:SNAP:METers
CALC:FSC:SLIS:SNAP:MET
If there are two signals with equal frequency difference found, the signal with lower frequency will be
selected.
If the signal list contains no data, an error is generated and this function cannot be performed.
A.07.00
EMI Receiver Mode Reference