10 Monitor Spectrum Measurement
Meas Setup
Key Path
Remote Command
Example
Dependencies
Preset
State Saved
Range
Initial S/W Revision
By Time
Specifies that the elements in the signal list will be sorted based on time.
Key Path
Example
Initial S/W Revision
Sort Order
Chooses between ascending and descending order.
Key Path
Remote Command
Example
Dependencies
Preset
State Saved
Initial S/W Revision
Auto Sort
If this is turned on, the measurement will perform signal sorting based on the sorting order and sorting type
selected before each new signal is added. Otherwise, the signal will be added into the signal list in
descending order of the trace amplitude level.
788
Meas Setup, Signal List, Sort Signals, By ∆
:CALCulate:SLISt:SORT:DLDelta DET1|DET2|DET3
:CALCulate:SLISt:SORT:DLDelta?
CALC:SLIS:SORT:DLD DET2
CALC:SLIS:SORT:DLD?
Selecting the ∆ Detector type to be sorted (pressing the key or sending the equivalent SCPI
command) will turn on the Auto Sort state, even if that ∆ Detector type was already selected.
DET1
Saved in instrument state
Detector 1|Detector 2|Detector 3
A.13.00
Meas Setup, Signal List, Sort Signals
CALC:SLIS:SORT:TYPE TIME
A.13.00
Meas Setup, Signal List, Sort Signals
:CALCulate:SLISt:SORT:ORDer ASCending |DESCending
:CALCulate:SLISt:SORT:ORDer?
CALC:SLIS:SORT:ORD DESC
Selecting the sort order (pressing the key or sending the equivalent SCPI command) will turn on the
Auto Sort state, even if that sort order was already selected.
ASCending
Saved in instrument state
A.13.00
EMI Receiver Mode Reference